Reconnecting Your Edision Combo Receiver to Your TV

by Michael Hickey August 11, 2026

Reconnecting Your Edision Combo Receiver

If your TV equipment was temporarily disconnected during building work etc, you should have three main cables to reconnect to your Edision receiver:

Locate the cable coming from your satellite dish. This normally has a metal screw-on connector called an F connector.

Carefully screw this cable onto the connection marked SAT IN or LNB IN on the back of the Edision receiver.

The Saorview aerial cable normally has a standard push-in TV aerial plug.

Push this firmly into the connection marked ANT IN or RF IN on the back of the Edision receiver.

Connect one end of the HDMI cable to HDMI OUT on the Edision receiver.

Connect the other end to an available HDMI socket on your TV. Take note of which socket you use, such as HDMI 1 or HDMI 2.

Plug the Edision receiver into the mains and switch it on.

Then turn on your television.

This is an important step.

Using your TV remote control, press the button marked:

The exact name will depend on the make of your television.

Select the HDMI input you used when connecting the receiver, such as HDMI 1 or HDMI 2.

You should now see the Edision menu or television picture on the screen.

Once the Edision picture appears, use the Edision remote control to change channels and operate the receiver as normal.

If you cannot see a picture, check that the TV is set to the correct HDMI input and that the Edision receiver is switched on.